Hi,
I am experiencing problems with a "Package for HCM Personnel Dev. PD & PA Receiver " for my client who has approximately 800 employees.
I have no errors in any of the phases, and I can see the TDMS SEND and RECEIVER jobs executing during the data transfer. However, the data transfer phase executes for approximately 1-2 minutes but when I check the tables in the RECEIVER the tables (such as HRP1001) are empty.
There are 42 tables selected, and CNVHCM_TR_TAB contains 1533 entries.
Below is a sample from the 'Transfer Selection Criteria' phase:
Transfer Target - System ECR / Client 210
The Transfer Program ran in PA Delete Mode
The Transfer Program ran in PD Delete Mode
Object Type: C // Total number: 5
Object Type: O // Total number: 5
Object Type: P // Total number: 28
Object Type: S // Total number: 31
Table HRITABNR - Time(ms) 10 - Entries 3
Table HRP1000 - Time(ms) 57 - Entries 65
Table HRP1001 - Time(ms) 39 - Entries 158
Table HRP1007 - Time(ms) 38 - Entries 5
Table HRP1018 - Time(ms) 39 - Entries 3
Table HRT1018 - Time(ms) 17 - Entries 3
Table PA0000 - Time(ms) 53 - Entries 47
Table PA0001 - Time(ms) 83 - Entries 76
So I would reasonably assume that if there are no errors anywhere in the Sender, Receiver or the Central system - that table HRP1001 would contain an extra 158 entries or PA0001 would contain 76 entries. This is not the case PA0001 is empty and HRP1001 contains the same number of rows as before the Data Transfer executed.
Has anyone come across this situation before, or got suggestions on troubleshooting the cause of no data transfer when all the phases are green.
Any assistance is appreciated. Regards,, Sheryl.